V35 - Victory Board™

For HALO B

The Victory Board™ is a direct plug and play replacement for all existing HALO B™ boards.

	PHOTO 1 Remove the 6 screws that hold the two body halves together. IMPORTANT! The Circuit board and the Back Plate MUST remain together in the left shell or you will break the switch off of the circuit board (which is not covered under warranty). Fully remove the screws, remove the batteries, and open the lid before attempting to pull the halves apart. The objective is to leave ALL drive components in the LEFT side of the body. TIP: Hold the Back Plate in the left shell with your thumbs while you remove the right shell so that it does not try to pull out when you remove the right half..
	PHOTO 2 Remove the Back Plate and Circuit Board together. You need to be careful because you can break the switch off. Take careful note of which way the connectors are on the circuit board.
	PHOTO 3 Slide the connectors off of the old board and install the new board in its place. Notice that the connectors go a specific way on the circuit board (as in the image to the left). Reassemble the HALO™.